Q&A
5 questions
Clear search
Q
I mulliganed during game setup, but I still don't have a single character card with a power cost of 0 in my hand.
A
Even without a power cost 0 character card in your hand, you set up the game by placing a character card with a power cost of 1 or more, an enchant card or an area enchant card face down in the battle zone.
If you set an enchant or area enchant card, it goes to the power charger or abyss "immediately" when the game starts, and its effect can't be used even if its power cost is 0. Your attack this turn (turn 1) counts as 0, so you take your opponent's attack as it is.
Q
When setting cards, can I choose not to play any cards from my hand?
A
No, you must always set at least 1 card from your hand.
Q
I lost the battle last turn, but I don't want to set 2 cards this turn.
A
A player who lost the previous turn may play up to 2 cards from their hand the next turn, but if you don't want to play 2, you can put just 1 card in the set zone. (You must always set at least 1.)
In this case you played 1 card from your hand, so you also draw 1 card from your deck at the end of the turn.
Q
I set an area enchant card without enough power for its cost. Does its effect take effect?
A
No, it doesn't.
However, its clock still counts when the Chronos is moved, and it's still swapped into set zone C at the area enchant swap.
While its power cost isn't met, it isn't put in the power charger or abyss even when the conditions for that are met, and it stays in set zone C unless it's swapped out.
Once enough power has built up, its effect can take effect.
Q
During game setup I had a character card in my hand. Can I set a card that isn't a character instead?
A
Yes. Whether or not you have character cards in your hand, you can set a card that isn't a character, but your attack on turn 1 counts as 0.
Cards that aren't characters are still set in the battle zone on turn 1.
